Today's Message Index:
----------------------
1. 06:13 AM - Thursday DOTH (Richard Iddon)
2. 07:08 AM - Re: Tie bar recess (rampil)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Weather again looking good in the north. I am proposing to fly to Bagby. Freebie
in Pilot mag. So far as I can see, refreshments available at the field. There
is a slope on 24/06 but wind is forecast to be NE which puts the landing on
the upslope.
Look forward to seeing anyone else who can make it.
Richard Iddon
G-RIXS
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Tie bar recess |
I built my kit 10 yrs ago and the tie bar was an-interbuild upgrade.
No big deal to cut a slot in the rear tunnel, just make only a few mm
larger in width and depth than absolutely needed since the tunnel
is structural for the lengthwise flexing load. I did not flox the rod
into the structure and would defer to Bud as to whether that is a
good idea or not.
BTW, the lateral attach points and bolts of the rod were the absolutely
most difficult part of the entire kit since it was a late addition and there
was no room for my fingers behind the seat/tank back.
--------
Ira N224XS
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=372268#372268
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|