Today's Message Index:
----------------------
1. 01:58 PM - Mono Landing gear (p-a.austin)
2. 02:56 PM - Re: Silicone Hoses for the Rotax 912 / 914 (Alan Carter)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Mono Landing gear |
Hello Kelv,
> Has anyone else encountered the LG04 pin locking up in the lower plate. I
> would
> prefer to see some similar bushes fitted to the swinging arm to prevent
> wear
> of the aluminium.
In my case I fabricated a little right angle plate that was welded to one
end of the pin so when the pin was installed the angle fitted snugly over
the top edge of the Landing gear frame stopping it from rotating, normal
washer and split pin at the
other end.
Peter
ZK-ZEB
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Silicone Hoses for the Rotax 912 / 914 |
Hi. rlborger(at)mac.com and All.
Yes my aircraft is flying, i am planning a complete hose change this winter.
Skydrive quoted me 610 for the rubber type, but i have e-mailed Stefan for a price
list of the Silicone hoses, i will get the clips you suggested,
At the moment on Evens none water coolant, so plan to continue using this coolant,
its expensive at 68 for 5 litres.
I am in a nice big hanger, but due to cost i am moving to a farm metal framed (^^)
shaped hanger, covered, but open at one end, so it will get down to say -
10 on the coldest nights.
Alan
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=383461#383461
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|