---------------------------------------------------------- Europa-List Digest Archive --- Total Messages Posted Tue 02/26/13: 2 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 05:56 PM - Stater Relay is 6 amps switch OK (Alan Carter) 2. 11:53 PM - Re: Stater Relay is 6 amps switch OK (Pete Lawless) ________________________________ Message 1 _____________________________________ Time: 05:56:11 PM PST US Subject: Europa-List: Stater Relay is 6 amps switch OK From: "Alan Carter" starter motor. I want to install a separate starter button, i have purchased a press button switch, rated at 6 amps @ 12 v and 6 amps @ 250v Is this OK. The switch spec. http://uk.rs-online.com/web/p/push-button-switches/6915242/? Alan Read this topic online here: http://forums.matronics.com/viewtopic.php?p=395139#395139 ________________________________ Message 2 _____________________________________ Time: 11:53:17 PM PST US From: "Pete Lawless" Subject: RE: Europa-List: Stater Relay is 6 amps switch OK Morning Alan I would think so. The starter switch circuit should be protected by a 2 amp CB according to the manual. My switch is nothing like as good as that one. Looking at the spec these are clearly intended for vehicle use so should be fine. You must have bought the last one the RS website is now showing your link as back order shipping 15 April. Another grey and damp morning up here. Glad I got a fly on Saturday it has not been fit since. My mate at Goodwood got a go in an Extra 330 on Sunday. He timed the take off - 4 seconds from start of roll to airborne at 70 kts. Mind you it is a 540 cu in engine that is 9.55 litres! Said it was a lovely aeroplane to fly even if you could not see where you were going. Pete -----Original Message----- From: owner-europa-list-server@matronics.com [mailto:owner-europa-list-server@matronics.com] On Behalf Of Alan Carter Sent: 27 February 2013 01:54 Subject: Europa-List: Stater Relay is 6 amps switch OK starter motor. I want to install a separate starter button, i have purchased a press button switch, rated at 6 amps @ 12 v and 6 amps @ 250v Is this OK. The switch spec. http://uk.rs-online.com/web/p/push-button-switches/6915242/? Alan Read this topic online here: http://forums.matronics.com/viewtopic.php?p=395139#395139 -- This message has been scanned for viruses and dangerous content by Houxou, and is believed to be clean. ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message europa-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/Europa-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/europa-list Browse Digests http://www.matronics.com/digest/europa-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.