Today's Message Index:
----------------------
1. 07:42 PM - Re: Is bonding FL16 to fuse a bad idea? (rparigoris)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Is bonding FL16 to fuse a bad idea? |
Hi group
Thx. for your help and input.
Having a pass through for the FL 18 / FL 16 pivot was a good idea.
I rigged wings with flap cross tube installed between flaps, lifted the flaps to
match wing jig, assembled FL 16s clamped and between the lugs on the flap cross
tube, installed FL 18s with a pivot s that had holes for string pass through,
put a bushing on the inner flap hinges to hold string centered, then when
everything was adjusted with string as centered as we could get, then Bondoed
the flap cross tube to fuse (lefty-righty centered), then FL 16s to fuse both
on top and bottom of floor.
In order to get registration of FL 18s perfectly parallel and aligned with FL 16s,
we used two stacks of black Nylon wide area washers (larger in diameter compared
to the white ones that come with the kit).
Insert hollow pivot and clamp and you get perfect and repeatable registration of
FL 18s for bonding.
Worked well.
Some pics after Fred Flaps:
http://www.europaowners.org/main.php?g2_itemId=86985
Ron Parigoris
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=405881#405881
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|