Today's Message Index:
----------------------
1. 12:46 AM - Windscreen and door gaps. (andrew cullum)
2. 01:40 AM - Re: fin ribs too long (jglazener)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Windscreen and door gaps. |
Hi Jeremy,
The windscreen and doors don't require
Any bid overlay,as the Araldite 420 bond is very good.
We simply filled the gap with Araldite
420/flox mix,carefully scraping off the excess with a blade to get the surface
as flat as possible to leave a minimum
amount of sanding when cured.
Best regards
Andy Cullum
G-CGDH.
Sent from my iPhone
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: fin ribs too long |
Hello Rowland,
Same problem here. I just lowered them to a position and angle that they did fit,
then marked positions for clecos on the port side by eye. The nose of the lower
rib needs trimming but that is covered in the manual. Don't drill the starboard
side because once you are working with the Araldite you will never find
them again. Bond and cleco stbd in one go.
http://europaowners.org/main.php?g2_itemId=100799
The ribs are there to provide torsional stiffness to the fin and are not load carrying.
Moving them around a bit shouldn't make any difference at all. They don't
even need to exactly parallel. I would steer away from reinforcements other
than the bond itself because that just adds weight.
--------
Jeroen
http://www.europaowners.org/main.php?g2_itemId=44165
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=409115#409115
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|