Today's Message Index:
----------------------
1. 01:17 AM - Re: choke cable routing (Rowland Carson)
2. 01:22 AM - =?iso-8859-1?Q?Re=3A_Europa-List=3A_Photo_from_Nov_2014_Photo-?= =?iso-8859-1?Q?Stream? (Rowland Carson)
3. 03:31 AM - Warp drive propellor blades (andrew cullum)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: choke cable routing |
On 3 Feb 2015, at 00:38, Gavin Lee <gavanne@iconz.co.nz> wrote:
> Yes you are right, the choke cable does pass very close to the bottom of the
throttle box. I put a little dimple in mine for a bit more clearance. You just
have to keep the bottom of the throttle box up as far as possible and the choke
cable will go past. It doesn't really matter if it touches as long as the throttle
box is not pushing it down too much. It'll work
Gavin - thanks for that reassurance.
in friendship
Rowland
| Rowland Carson ... that's Rowland with a 'w' ...
| <rowlandcarson@gmail.com> http://www.rowlandcarson.org.uk
| Skype, Twitter: rowland_carson Facebook: Rowland Carson
| pictures: http://picasaweb.google.com/rowlandcarson
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | =?iso-8859-1?Q?Re=3A_Europa-List=3A_Photo_from_Nov_2014_Photo-?= |
=?iso-8859-1?Q?Stream?
On 2 Feb 2015, at 23:35, jonathanmilbank <jdmilbank@yahoo.co.uk> wrote:
> I only have one photo to show my choke knob mounted in a bracket on
top of the tunnel and level with the front face of the instrument panel
Jonathan - thanks - I forgot that the original instructions called for
the choke knob to be mounted at the bottom of the radio panel. The
current 912S engine installation manual shows it positioned as in the
attached picture. Gavin=92s post assures me there is just room to get
the choke cables past the bottom of the throttle box.
in friendship
Rowland
| Rowland Carson ... that's Rowland with a 'w' ...
| <rowlandcarson@gmail.com> http://www.rowlandcarson.org.uk
| Skype, Twitter: rowland_carson Facebook: Rowland Carson
| pictures: http://picasaweb.google.com/rowlandcarson
Message 3
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Warp drive propellor blades |
Hi there
Does anyone out there have a set of standard 62" broad blade warp drive propellor
blades surplus to requirements and if so how much you
Want for them?
Best regards
Andy Cullum G-CGDH.
Sent from my iPhone
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|