---------------------------------------------------------- Europa-List Digest Archive --- Total Messages Posted Sat 03/07/15: 4 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 03:17 PM - Tri-Gear Landing Gear Leg (Kelvin Weston) 2. 03:46 PM - Rear Wing Pin Tie-Bar in Fuselage (Kelvin Weston) 3. 11:02 PM - Door gas-springs (=?utf-8?Q?Gert_Dalgaard_S=C3=B8rensen?=) 4. 11:40 PM - Re: Door gas-springs (Kevin Challis) ________________________________ Message 1 _____________________________________ Time: 03:17:27 PM PST US Subject: Europa-List: Tri-Gear Landing Gear Leg From: "Kelvin Weston" Hi All Have just tried fitting the brake caliper mounting plates MG02 to the main gear legs and found that the holes for the AN5 bolts do not align. One leg is quite close and would probably go after a bit of fettling, but the other leg is half a hole out. Has anyone else had this problem? I have checked the alignment of the drilled holes on the problem leg and both the mounting bolt hole at the top of the leg and the axle hole are vertical when the leg is laid on a flat surface, so that's ok. The problem looks like the hole in the axle for the torque plate mounting bolt has not been drilled on the centreline. This can be seen in the second picture. -------- Regards Kelv Weston Kit 497 kelv@kdweston.biz Read this topic online here: http://forums.matronics.com/viewtopic.php?p=439135#439135 Attachments: http://forums.matronics.com//files/dscf1096_997.jpg http://forums.matronics.com//files/dscf1099_657.jpg ________________________________ Message 2 _____________________________________ Time: 03:46:22 PM PST US Subject: Europa-List: Rear Wing Pin Tie-Bar in Fuselage From: "Kelvin Weston" Hi Again The later Cockpit Modules had a pre-moulded groove in the rear centre tunnel to accommodate the rear wing pin tie-rod (mod 52). Does the groove still need to be glassed over as shown in the current build manual (chap 27) thus retaining the tie-rod? I'm thinking that this was only to restore the structural integrity of the rear tunnel on the earlier cockpit modules and is probably not required on the CM's with the pre-moulded groove. Any thoughts? I would be interested to hear what other builders with the later CM's have done. -------- Regards Kelv Weston Kit 497 kelv@kdweston.biz Read this topic online here: http://forums.matronics.com/viewtopic.php?p=439136#439136 ________________________________ Message 3 _____________________________________ Time: 11:02:06 PM PST US From: =?utf-8?Q?Gert_Dalgaard_S=C3=B8rensen?= Subject: Europa-List: Door gas-springs Hi all My door-gassprings seems to be a little tired :) Anyone who know where I can purchase two new? Nice sunday to every one. Regards Gert Gert Dalgaard OY-GDS / Europa mono / 914 / 750 hrs. ________________________________ Message 4 _____________________________________ Time: 11:40:20 PM PST US Subject: Re: Europa-List: Door gas-springs From: Kevin Challis This company will service and recharge them. Refill to 185 N http://www.industrialgassprings.com > On 8 Mar 2015, at 06:58, Gert Dalgaard Srensen wrote: > > > Hi all > > My door-gassprings seems to be a little tired :) > Anyone who know where I can purchase two new? > Nice sunday to every one. > > Regards Gert > > Gert Dalgaard > OY-GDS / Europa mono / 914 / 750 hrs. > > > > ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message europa-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/Europa-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/europa-list Browse Digests http://www.matronics.com/digest/europa-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.