Today's Message Index:
----------------------
1. 11:09 AM - Engine offset shims (William Daniell)
2. 06:24 PM - Re: Engine offset shims (William Daniell)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Engine offset shims |
I have just mounted the engine.
My question is does any one remember what the effect of each shim is...my
offset is 8mm and I need 26mm - I am just trying to avoid the trial and
error (being lazy).
yours
Will
William Daniell
LONGPORT
+57 310 295 0744
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Engine offset shims |
Forget that...being stupid...it's 5:1 ratio between the mount roughly 4"
from cwntre line and the measuring point 20" from the centre line
Will
On May 2, 2015 1:11 PM, "William Daniell" <wdaniell.longport@gmail.com>
wrote:
> I have just mounted the engine.
>
> My question is does any one remember what the effect of each shim is...my
> offset is 8mm and I need 26mm - I am just trying to avoid the trial and
> error (being lazy).
> yours
>
> Will
>
>
> William Daniell
> LONGPORT
> +57 310 295 0744
>
> *
>
>
> *
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|