---------------------------------------------------------- Europa-List Digest Archive --- Total Messages Posted Thu 03/17/16: 4 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 12:39 AM - Fw: top cowl carb air inlet (Alan Twigg) 2. 02:35 AM - Re: Fw: top cowl carb air inlet (GRAHAM SINGLETON) 3. 03:25 AM - Re: top cowl carb air inlet (flyingphil2) 4. 05:08 AM - Re: top cowl carb air inlet (Rowland Carson) ________________________________ Message 1 _____________________________________ Time: 12:39:25 AM PST US From: Alan Twigg Subject: Fwd: Europa-List: top cowl carb air inlet Posting this for Neville, re his cowlings. Sent from my iPad Begin forwarded message: > From: Neville Eyre > Date: 16 March 2016 at 23:45:54 GMT > To: alan.twigg775@gmail.com > Subject: Fwd: Europa-List: top cowl carb air inlet > > Hi Alan, I tried to post this on the Forum, didn't get through, can you po st it for me ? > Cheers, > Nev > > > -----Original Message----- > From: Neville Eyre > To: europa-list > Sent: Wed, Mar 16, 2016 8:13 pm > Subject: Re: Europa-List: top cowl carb air inlet > > Hi Rowland, > Glad to hear you are on with it, smart thing would have been to call or em ail me directly with your question ? > All pretty straight forward, no need to do any glassing / cutting of the c owls, I designed and manufactured them so you don't have to ! If it takes yo u more than a morning to fit them you are doing something wrong ! > Air to the carbs is taken from under the cowl, no chance of water ingress v ia a NACA scoop when parked.. Prefered filters are the conical K&N's direct o n the carbs, but the Europa airbox set up will work. The airbox / NACA set u p was needed with the standard XS cowls as it gets hotter than hell in there with no through airflow. Air temps inside my upper cowl taken at shutdown a fter a 2 hour flight were below ambient, nothing above the baffles got hot e nough to darken the 40 C bar on the temp' test strips. > The baffles will direct cold air all the way to the rear of the cowl, and w ith the top of the tunnel gap blocked off with a baffle, little heat build u p there after shutdown. Baffles also prevent the exhaust headers cooking the fuel in the carbs. > I'm sure you had copies of the baffle templates [ baffles made from soft a lloy] if not I can send you a set. With this installation, you can run on th e ground at 2,000 rpm all day, and do the 5 minute WOT run for the LaaLaaLan d pre 1st flight test without burning the cowls or chucking the coolant over board [BTW use 50/50 antifreeze / water, not the ''other stuff'' ] > As you only had the cowls [ not my complete kit] just follow the Europa FW F Manual as far as mounting and plumbing the engine, in the same position as the XS Europa kit. > Cheers, > Nev > > > -----Original Message----- > From: Rowland Carson > To: Europa e-mail list list > Sent: Tue, Mar 15, 2016 8:22 pm > Subject: Europa-List: top cowl carb air inlet > > > > I=99ve bought Neville Eyre=99s cowl set and I am wondering how to get the air into the cowling to the plenum chamber for the carbs. > > The Europa manual describes making a NACA duct on the top cowl to connect t o the plenum chamber, at a marked position. If I understand the manual corre ctly, it appears that a buck or splash moulding is supplied with the factory cowl set. It is pushed through the cowl from the outside and the duct is la id up inside the cowl against the splash moulding. > > Neville has not supplied anything to make the NACA duct for the plenum cha mber. Obviously I can work out the position on the cowl from careful measure ment of the plenum relative to the firewall, but I don=99t have any in formation or pattern for the shape and size of the NACA duct. > > Does anyone have one of these splash mouldings from the factory that I cou ld borrow, please? I don=99t need it right now, but want to make sure I have some way of dealing with this problem when I come to it. > > Or, if I=99m not understanding how the NACA duct is made, can someon e please explain it to me! > > in friendship > > Rowland > > > > ========================== ========= ========================== ========= ========================== ========= ========================== ========= ========================== ========= > > > ________________________________ Message 2 _____________________________________ Time: 02:35:42 AM PST US From: GRAHAM SINGLETON Subject: Re: Fwd: Europa-List: top cowl carb air inlet Rowlandyou could make a plug from blue foam, wrap it with grey duct tape an d use that. Shape is not too critical.Graham On Thursday, 17 March 2016, 7:40, Alan Twigg wrote: Posting this for Neville, re his cowlings. Sent from my iPad Begin forwarded message: From: Neville Eyre Subject: Fwd: Europa-List: top cowl carb air inlet Hi Alan, I tried to post this on the Forum, didn't get through, can you pos t it for me ?Cheers,Nev=C2-=C2------Original Message----- From: Neville Eyre Sent: Wed, Mar 16, 2016 8:13 pm Subject: Re: Europa-List: top cowl carb air inlet Hi Rowland,Glad to hear you are on with it, smart thing would have been to call or email me directly with your question ?All pretty straight forward, no need to do any glassing / cutting of the cowls, I designed and manufactu red them so you don't have to ! If it takes you more than a morning to fit them you are doing something wrong !Air to the carbs is taken from under th e cowl, no chance of water ingress via a NACA scoop=C2-when parked.. Pref ered filters are the conical K&N's direct on the carbs, but the Europa airb ox set up will work. The airbox / NACA set up was needed with the standard XS cowls as it gets hotter than hell in there with no through airflow.=C2 -Air temps inside=C2-my upper cowl=C2-taken at shutdown after a 2 hou r flight were below ambient, nothing above the baffles got hot enough to da rken=C2-the 40=C2-C bar on the=C2-temp' test strips.The baffles will direct cold air all the way to the rear of the cowl, and with the top of th e tunnel gap blocked off with a baffle, little heat build up there after sh utdown. Baffles also prevent the exhaust headers cooking the fuel in the ca rbs.I'm sure you had copies of the baffle templates [ baffles made from sof t alloy] if not I can send you a set. With this installation, you can run o n the ground at 2,000 rpm all day, and do the 5 minute WOT run for the LaaL aaLand pre 1st=C2-flight test without burning the cowls or chucking the c oolant overboard=C2- [BTW use 50/50 antifreeze / water, not the ''other s tuff'' ]As you only had the cowls [ not my complete kit] just follow the Eu ropa FWF Manual as far as mounting and plumbing the engine, in the same pos ition as the XS Europa kit.Cheers,Nev=C2-=C2------Original Message----- From: Rowland Carson Sent: Tue, Mar 15, 2016 8:22 pm Subject: Europa-List: top cowl carb air inlet I=99ve bought Neville Eyre=99s cowl set and I am wondering how to get the air into the cowling to the plenum chamber for the carbs. The Europa manual describes making a NACA duct on the top cowl to connect t o the plenum chamber, at a marked position. If I understand the manual corr ectly, it appears that a buck or splash moulding is supplied with the facto ry cowl set. It is pushed through the cowl from the outside and the duct is laid up inside the cowl against the splash moulding. Neville has not supplied anything to make the NACA duct for the plenum cham ber. Obviously I can work out the position on the cowl from careful measure ment of the plenum relative to the firewall, but I don=99t have any i nformation or pattern for the shape and size of the NACA duct. Does anyone have one of these splash mouldings from the factory that I coul d borrow, please? I don=99t need it right now, but want to make sure I have some way of dealing with this problem when I come to it. Or, if I=99m not understanding how the NACA duct is made, can someone please explain it to me! in friendship Rowland | Rowland Carson ... that's Rowland with a 'w' ... | http://www.rowlandcarson.org.uk | Skype, Twitter: rowland_carson Facebook: Rowland Carson | pictures: http://picasaweb.google.com/rowlandcarson ========= target="_blank">www.buildersbooks.com blank">http://www.matronics.com/contribution ========= rget="_blank">http://www.matronics.com/Navigator?Europa-List ========= p://forums.matronics.com ========= blank">http://www.matronics.com/contribution ========= ________________________________ Message 3 _____________________________________ Time: 03:25:07 AM PST US Subject: Europa-List: Re: top cowl carb air inlet From: "flyingphil2" Thanks for the link Jon, that looks like a really nice installation. Read this topic online here: http://forums.matronics.com/viewtopic.php?p=453888#453888 ________________________________ Message 4 _____________________________________ Time: 05:08:32 AM PST US Subject: Re: Europa-List: top cowl carb air inlet From: Rowland Carson On 2016-03-17, at 07:38, Alan Twigg wrote: > Posting this for Neville, re his cowlings. Alan - thanks for that (and thanks to all who replied to my question). Ive sent a message direct to Neville and hope he will now be able to provide the documentation for the cowl and baffle installation - Ive had nothing in writing so far, and cannot find his cowl mod on the LAA mod list. in friendship Rowland | Rowland Carson ... that's Rowland with a 'w' ... | http://www.rowlandcarson.org.uk | Skype, Twitter: rowland_carson Facebook: Rowland Carson | pictures: http://picasaweb.google.com/rowlandcarson ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message europa-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/Europa-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/europa-list Browse Digests http://www.matronics.com/digest/europa-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.