Today's Message Index:
----------------------
1. 06:13 AM - Re: Arplast PV50 - Help with Vibration Data (italianjon)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Arplast PV50 - Help with Vibration Data |
Hi Graham,
Thanks for this reply. I will try that next weekend.
I tried searching for anything online from Jerry Davies, and couldn't find anything
with the details. However your description is easy to follow. I have two
questions:-
1) On the Arplast there is the mass-balance arm, sleeve, bearing and alignment
dog - should I statically balance with these items on or off? I am assuming off.
2) I'm a little confused by your comment about the mass being the same. I have
understood this to be the mass of the blade itself, not the reading on the scales.
If the nail 2/3rds along the blade length was in the same position on each
blade, then it should show the same reading, right? Or have I misunderstood
something.
Best regards
Jon
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=454172#454172
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|