---------------------------------------------------------- Europa-List Digest Archive --- Total Messages Posted Sun 08/21/16: 2 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 10:29 PM - Re: Cooling issues XS 914 on the ground (Roland) 2. 11:34 PM - Re: Cooling issue (Roland) ________________________________ Message 1 _____________________________________ Time: 10:29:37 PM PST US Subject: Europa-List: Re: Cooling issues XS 914 on the ground From: "Roland" Remi, I can tell you, that the 7-row oil cooler in my setup is sufficient under ALL conditions. That also (like many other things I've learned about cooling) is far from logical, since I always had the oil too hot in summer even in cruise climb 90KIAS with the 13-row cooler (which I donated to the Europa Club :-) ) when it was installed in tandem with the radiator previously. Now I only left a gap of just 1 cm below the radiator with an aluminum sheet installed in the tunnel, so that I have in sum the radiator surface and this 1 cm gap below, where all air has to pass through in the tunnel. The oil cooler has now 4 rows overlapping behind the radiator and only 3 rows get cool air from this 1 cm gap. In addition the aluminum sheet in the tunnel, which guides the air through the radiator extends behind the oil cooler, so that no cool air is lost below the oil cooler. Regards Roland PH-ZTI XS TG 914 Read this topic online here: http://forums.matronics.com/viewtopic.php?p=459739#459739 ________________________________ Message 2 _____________________________________ Time: 11:34:14 PM PST US Subject: Europa-List: Re: Cooling issue From: "Roland" Bud, no plug&play indeed. And I also fully agree, that a compromise has to be found (ideally the best one) with a fix setup. I'm just happy, that I finally (after >5 years of ownership) managed to find a good compromise for me, although I did many things unconventionally and even some different to your suggestions ;-) . I have now a good basis for further little improvements - if one day I ever should have the feeling that I miss tinkering (at the moment I write this, I cannot imagine it). Happy landings Roland PH-ZTI XS TG 914 Read this topic online here: http://forums.matronics.com/viewtopic.php?p=459740#459740 ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message europa-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/Europa-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/europa-list Browse Digests http://www.matronics.com/digest/europa-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.