Today's Message Index:
----------------------
1. 02:51 PM - Trip report Gower Beaches South Wales UK (graeme bird)
2. 06:45 PM - 10 inch Dynon in a Mono (Martin Tuck)
3. 07:57 PM - Re: 10 inch Dynon in a Mono (Fred Klein)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Trip report Gower Beaches South Wales UK |
https://forums.flyer.co.uk/viewtopic.php?f=67&t=102407
--------
Graeme Bird
G-UMPY - Mono Classic/XS FFW 912S, Woodcomp 3000/3W CS, trutrak Gemini 2 axis
ap, pflarm, ads-b out, 8.33khz, mode S, FP 5, Aera500 & SD on Nexus,
250 hours & 4 years on the Mono, 880 total
g(at)gdbmk.co.uk
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=463614#463614
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | 10 inch Dynon in a Mono |
Hi,
I'm still determined to upgrade my Europa monowheel to an EFIS and have
pretty much settled on the 10 inch Dynon display.
So I'm in my early stages of panel planning I have determined that the
standard mono panel moulding is not quite wide enough for the 10 in screen.
It needs building up to the left by maybe 1/2 inch which starts to
encroach into the recess for the gear/flap handle.
My question is, has anyone else already done this and if so, did you
make some kind of gear/flap handle extension that would make it easier
to push and pull the handle up and down?
I'd be interested in any solutions along with any pictures.
Thanks,
Martin Tuck
Wichita, Kansas
Message 3
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: 10 inch Dynon in a Mono |
Martinthough I opted for the 7=9D Skyview, principally
because I have a stand-alone EMS and will not have to split-screen the
Dynon to get that data, because of associated layout decisions regarding
back up steam gauges, I too needed to decrease the width of the recess
for the gear/flap handle by approx. 1/2=9Da bit of handy
hacksaw work is all it tookI=99ll send pixs directly to
youFred
> On Dec 1, 2016, at 6:44 PM, Martin Tuck <MJKTuck@cs.com> wrote:
>
> I'm still determined to upgrade my Europa monowheel to an EFIS and
have pretty much settled on the 10 inch Dynon display.
>
> So I'm in my early stages of panel planning I have determined that the
standard mono panel moulding is not quite wide enough for the 10 in
screen.
>
> It needs building up to the left by maybe 1/2 inch which starts to
encroach into the recess for the gear/flap handle.
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|