Today's Message Index:
----------------------
1. 01:29 PM - Re: Airmaster or Woodcomp? (jglazener)
2. 02:08 PM - Dynon Pitot/AOA (Martin Tuck)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Airmaster or Woodcomp? |
David, I would like to discuss this further offline, but can't get through on your
email address. Could you drop me a line? j.glazener14(at)gmail.com
--------
Jeroen
http://www.europaowners.org/main.php?g2_itemId=44165
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=463770#463770
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Anyone fitted the Dynon Pitot/AOA sensor? The instructions recommend
fitting it up to 12 inches behind the leading edge. As it does not have
a static port I plan to continue using the Europa pitot/static (for a
back up ASI) and as a common static source.
The Europa pitot/static is 12 inches behind the spar so quite a ways
back from Dynons suggestion.
Any problems utilizing the same area next to the Europa pitot/static
tubes for the Dynon pitot/AOA do you think. I want to run the pitot/AOA
lines along the same path.
If anyone has experience of this location I would like to hear. It
probably doesn;t matter for the pitot part - just wasn't sure if the AOA
was critical of position.
Regards,
Martin Tuck
N152MT
Wichita, KS
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|