Today's Message Index:
----------------------
1. 08:14 PM - Rotax 914 Exhaust Leak (djaflyact)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Rotax 914 Exhaust Leak |
I have a motor glider with the 914 engine. Just bought a good CO detector and was
surprised that I have been flying for years with low level CO in the cockpit.
I did the classic shop vac blowing in the exhaust to see if I could determine
any leaks. To my huge surprise, I didn't need soapy water to find a leak. All
four slip joints are blowing air like crazy. The fit seems very loose. I did
the same test on a friend's newer 914 and there was no leak at all.
Anyone have any experience with this. I loaded up the joint with anti seize compound
as a test and the leak was reduced significantly. The cockpit readings at
idle lowered from 20 to 5 on the ground. I am considering using a pipe expanding
tool to slightly increase the smaller pipe to make it a tight fit. The metal
is stainless steel and I don't know if that can be done. It won't take much
to provide the increased tightness.
A big concern is the cost off the exhaust parts if I need to replace them. Rotax
is extremely proud of their parts. the 4 pipes and the gatherer total approximately
$4700. That is crazy.
Any isights would be appreciated.
Dave A
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=465414#465414
Attachments:
http://forums.matronics.com//files/screen_shot_2016_12_29_at_74111_pm_173.png
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|