Today's Message Index:
----------------------
1. 06:37 PM - Turning propeller backwards (jonathanmilbank)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Turning propeller backwards |
What if someone's been turning my propeller/Rotax 912ULS backwards through several
revolutions? I know in that case oil will be "sucked" out of the hydraulic
tappets and damage would/could be caused to the valve train.
Would I hear clattering on engine start and would the noise continue? Or after
initial clattering, would the tappets fill within a few minutes and the clattering
disappear? The trouble is that someone else did the first start and he didn't
report unusual noises.
The engine has subsequently run for two hours including four flights. Should I
now undertake investigations for damage and if so, what should I be doing to put
this worry behind me? Rocker covers off and look at valve spring caps? Check
magnetic plug? Prime the oil system again to purge air out of the tappets?
Your advice would be very welcome, thanks.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=474335#474335
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|