Today's Message Index:
----------------------
1. 08:15 AM - Dynon Servo Wiring (Erich Trombley)
2. 12:14 PM - Re: (philip george)
3. 01:18 PM - Re: (Steve Ivell)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Dynon Servo Wiring |
Hi Martin,
I too have both of my servos near each other. I ran only one wire bundle per the
manual, as if you were installing only one servo. However, at the servo end
I made a daisy chain so that I could extend the wire harness to the other servo.
Then you only need one yellow disconnect wire run to a single switch on your
panel or stick. Hope that makes sense.
Erich,
N28ET ClassicMono 914
____________________________________________________________
Unbelievable German World War 2 Photo Shocks Americans
pro.naturalhealthresponse.com
http://thirdpartyoffers.juno.com/TGL3131/5af06cfa753ba6cf86b78st01duc
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Steve have you fitted the hinges yet?
Regards
Phil George mono xs
Sent from Huawei MediaPad
-------- Original Message --------
Subject: Europa-List:
From: Steve Ivell
CC:
Hi Folks
I am close to finishing the wings on my XS kit and am concerned about the f
it of the Ailerons as they seem to be very snug in the wing. Am I supposed
to trim the fibreglass of the lower skin prior to the closeout or is adjust
ment made after??
Steve Ivell
Kit Builder
Message 3
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Europa-List: |
Just in the process of fitting the hinges and having studied the build manu
al again I realise the aileron is used to pack out the space when the close
out panel is bonded in.
Steve Ivell
Pestproof
07971 128842
________________________________
From: owner-europa-list-server@matronics.com <owner-europa-list-server@matr
onics.com> on behalf of philip george <philipgeorge347@hotmail.com>
Sent: Monday, May 7, 2018 8:12:49 PM
Subject: Re: Europa-List:
Steve have you fitted the hinges yet?
Regards
Phil George mono xs
Sent from Huawei MediaPad
-------- Original Message --------
Subject: Europa-List:
From: Steve Ivell
CC:
Hi Folks
I am close to finishing the wings on my XS kit and am concerned about the f
it of the Ailerons as they seem to be very snug in the wing. Am I supposed
to trim the fibreglass of the lower skin prior to the closeout or is adjust
ment made after??
Steve Ivell
Kit Builder
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|