Today's Message Index:
----------------------
1. 01:51 AM - Re: Arplast Propeller problems (BobD)
2. 04:05 AM - Loose fitting M10x110 bolts in engine frame MT05 (Eddie)
3. 01:34 PM - Re: IMC Night application - Propeller (carlp101)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Arplast Propeller problems |
The euphoria from the solution to my recent problem (loose wire) didn't last long,
as the motor on my Propeller has now failed completely :(
I wish to replace the existing 6V motor with a 12v one, as this is likely to be
more robust, but I have been advised by the LAA that I need to submit a MOD2
to do this. As this may take some time, I wondered if anyone has a old, spare
6V model I could borrow or buy to use in the meantime ?
--------
Bob Dawson
Europa XS TG || 912 ULS || G-NHRJ || Dynon Skyview || PilotAware || SmartAss3
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=487488#487488
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Loose fitting M10x110 bolts in engine frame MT05 |
Hello All,
I have just purchased a new firewall forward kit from Europa and 912ULS and have
a question about the MT05 frame they recently supplied.
The manual shows (p3-1 diagram) that this MT05 frame is bolted to the Rotax ring
mount with 4x M10x110 bolts with Binx nuts.
Whilst trial fitting the frame the bolts are really loose in the MT05 tubes. The
bolts are about 2mm smaller than the ID of the tubes and there is no washer
to spread the load or plug specified to keep the bolts central. Can this really
be right?
Also no washer specified to go under the Binx but. Is that right?
Could someone with an older frame please let me know what the ID and OD (or ID
and wall thickness) is of the tubes that the M10x110 bolts go through.
When one compares the LG01 attachment tubes there is quite a difference in tolerances.
Thanks
Ed
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=487490#487490
Message 3
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: IMC Night application - Propeller |
So.G-URMS was tested for night flying tonight. All went well. Touch and go's and
a full stop at Blackbushe completed. This should be the final step in the IMC
certification. Only the pa paperwork left ( I hope ).
ATB
Carl
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=487496#487496
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|