Today's Message Index:
----------------------
1. 09:28 AM - Re: I'm puzzled, again! (Remi Guerner)
2. 12:07 PM - Re: I'm puzzled, again! (JonathanMilbank)
3. 02:54 PM - Manifold pressure (Eoin Maguire)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: I'm puzzled, again! |
As an addition to my previous post regarding the kick-back problem, I believe it
is useful to add the following regarding the sprag clutch replacement. After
reviewing the different issues of the 912 IPC, from 2017 up to now, I discovered
that Rotax has made several changes in that area over the years. The sprag
clutch itself has not been changed but the sprag clutch housing was modified
several times. Housing P/N 852405 was introduced in May 2008 with the following
comment: "new housing with expanded space for sprag clutch". Then in January
2017, P/N 852406 was introduced with the very same comment. I guess the changes
were designed to improve the behaviour of the sprag clutch.
My conclusion: when replacing the sprag clutch, it is critical to replace also
the housing and make sure the P/N is the last version.
Remi
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=487913#487913
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: I'm puzzled, again! |
Thanks also for this latest observation, Remi. Next time that I need to replace
the sprag clutch, I'll keep the housing issue in mind. But "next time" will hopefully
be a very long time!
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=487915#487915
Message 3
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Manifold pressure |
Hi All
Does anyone know the correct spec piping for manifold pressure to gauge plumbing
?
Kind Regards
Eoin
Sent from my iPhone
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|