Today's Message Index:
----------------------
0. 09:26 PM - Value of the List... (Matt Dralle)
1. 02:43 PM - Control stick tube height (n7188u)
2. 05:32 PM - Re: Control stick tube height (Kingsley Hurst)
Message 0
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Value of the List... |
If you look forward to checking your List email everyday (and a lot of you have
written to say that you do!), then you're probably getting at least $20 or $30
worth of Entertainment from the Lists each year. You'd pay twice that for a
subscription to some magazine or even a dinner out. Isn't the List worth at least
that much to you? Wouldn't it be great if you could pay that amount and get
a well-managed media source free of advertising, SPAM, and viruses? Come to
think of it, you do... :-)
Won't you please take a minute to make your Contribution today and support these
Lists?
http://www.matronics.com/contribution
Or, drop a personal check in the mail to:
Matt Dralle / Matronics
581 Jeannie Way
Livermore CA 94550
USA
I want to say THANK YOU to everyone that has made a Contribution thus far during
this year's List Fund Raiser!! These Lists are made possible exclusively through
YOUR generosity!!
Thank you for your support!
Matt Dralle
Email List Admin.
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Control stick tube height |
Dear forum members,
My control sticks seems to have modified at their end to fit Infinity grips (which
I am not going to use) and I need to check whether they were cut down to make
them shorter or not.
I measured 19 inches from the floor to the top of the stick tube when the stick
was about vertical.
Is this correct or if not how much was the stick cut down?
Regards,
Chris
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=492888#492888
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Control stick tube height |
Chris,
I have measured from floor to top of sticks on two aircraft for you . .
. . . . one is 19.7" and the other 20.9" so take your pick!
IMO, your 19" is plenty long enough.
Regards
Kingsley in Oz
On 15.11.19 8:42 am, n7188u wrote:
>
> Dear forum members,
>
> My control sticks seems to have modified at their end to fit Infinity grips (which
I am not going to use) and I need to check whether they were cut down to
make them shorter or not.
>
> I measured 19 inches from the floor to the top of the stick tube when the stick
was about vertical.
>
> Is this correct or if not how much was the stick cut down?
>
> Regards,
> Chris
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|