Today's Message Index:
----------------------
1. 04:14 AM - Re: Monowheel brake =?ISO-8859-1?Q?fill=99n?==?ISO-8859-1?Q?=99bleed? (Hitchflight)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Monowheel brake =?ISO-8859-1?Q?fill=99n?==?ISO-8859-1?Q?=99bleed? |
Hi Pete.
I was given the advice below by a Club member who is sadly no longer with us. I
have personally used this method successfully for many years.
-
Bleeding the brakes on the XS MONOWHEEL
Screw the alu reservoir into the filler hole on the master cylinder. Then fill
the syringe with fluid, attach a short length of plastic tubing, and attach to
the bleed nipple on the slave cylinder. Slacken the bleed nipple and inject the
fluid. When all 10 mls are injected, tighten the bleed nipple, refil the syringe
and repeat. It takes 2 - 3 10 ml syringes to fill the system. When fluid
with no air bubbles flows into the reservoir, tighten the bleed nipple and remove
some fluid from the reservoir until it is about a third full. Then pull the
brake lever until no more air is expelled. Release the lever slowly and watch
the level of fluid in the reservior as it drops to make sure no air is sucked
into the master cylinder. Repeat until no more air is expelled from the master
cylinder. Finally pull the brake lever back just a quarter of an inch, empty
the reservoir with the syringe, and release the brake lever, so that the fluid
level drops just below the filler hole in the master cylinder. That then lets
you unscrew the reservoir without brake fluid leaking everywhere. Replace
the filler cap, check the bleed nipple is fully tightened, and the system should
be bled.
Need Allan keys [Idea]
-
This information is probably worth adding to our Europa website. Will check with
the experts on the Committee and if OK will add.
Regards
Bob
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=493703#493703
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|