Today's Message Index:
----------------------
1. 06:03 PM - Mono Landing Gear Bungee (Martin Tuck)
2. 07:31 PM - Re: Mono Landing Gear Bungee (Tim Ward)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Mono Landing Gear Bungee |
Can anyone recall the diameter of the bungee used to assist gear
retraction on the mono? 3/8 inch maybe?
As I recall there is not much room for it to squeeze through as you go
around the frame. I think 1/2 inch would be too big - I'm pretty sure it
was bigger than 1/4 inch.
Also, what would be a good length to buy?
Regards,
Martin Tuck
Wichita, KS
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Mono Landing Gear Bungee |
Hi Martin,
Just measured the old bungee I replaced.
Thickness 7mm = 5/16 just short 3/8. So 3/8
Length 7m = 30ft
Hope that helps and I am correct.
Cheers,
Tim
Sent from my iPhone
Tim Ward
12 Waiwetu Street
Fendalton
CHRISTCHURCH 8052
Hom 03315166
> On 3/02/2021, at 15:11, Martin Tuck <MJKTuck@cs.com> wrote:
>
>
> Can anyone recall the diameter of the bungee used to assist gear retraction on
the mono? 3/8 inch maybe?
>
> As I recall there is not much room for it to squeeze through as you go around
the frame. I think 1/2 inch would be too big - I'm pretty sure it was bigger
than 1/4 inch.
>
> Also, what would be a good length to buy?
>
> Regards,
> Martin Tuck
> Wichita, KS
>
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|