Today's Message Index:
----------------------
1. 06:27 AM - Re: Plastic cable conduit for electrical cabling (Mike Christine Duane)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Plastic cable conduit for electrical cabling |
Nicely done. Stiffening the sill is a very good thing.
Sent from my iPhone
> On Mar 13, 2021, at 9:23 PM, Fred Klein <freddythek10@gmail.com> wrote:
>
> In addition to concealing wires heading aft, I wanted to stiffen the door sill;
I used a quarter round section cut from plastic pipe as a mold using 3 layers
of BIDfore and aft of the sill, I used a half round pipe as a mold using layers
of BIDas a transition, I carved and sanded a piece of foam as a mold, overlade
w/ 2 layers of BID as a transition which I secure w/ a few dabs of silicone.
>
> I did use piece of very lightweight, flexible 3/4 irrigation pipe to conceal
wires leading to an overhead console; pipe was wrapped with 3 layers of BID to
stiffen the roll bar, fwiwall in all, tidy enough.
>
> pixs below.
>
> Fred
> A194
>
> <DSCN3225.jpeg>
>
> <DSCN3255.jpeg>
>
> <DSCN7397.jpeg>
>
> <DSCN7398.jpeg>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|