Today's Message Index:
----------------------
1. 10:50 AM - sealing up the gas tank seat back (William Daniell)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | sealing up the gas tank seat back |
I am coming towards the end of my tank build...the left outlet was too
close to the torque tube and had to be redone. And the spacers which
stop the tank bulging had to have their top angle removed (didnt fit) and
nut plates put on. i still have to fit the filler tube . And then sand
to ensure no flakes could block the outlets. And then put the top on.
And adjust the hole for the filler tube in yhe rear bulkhead.... No
matter. I can feel I'm getting close.
The next step is engine testing before final closing.
Wrt closing, to those that have done this before how does one go about the
inside reinforcements? (outside seems straightfoward) Any wisdom to share
thanks
will
William Daniell
+1 786 878 0246
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|