Today's Message Index:
----------------------
1. 12:45 AM - Re: The Obsidian Files - Chapter 1 - Pigs In Space & Other S (Area-51)
2. 05:25 PM - Re: 914 Air Filter (h&jeuropa)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: The Obsidian Files - Chapter 1 - Pigs In Space & Other |
S
The doors are subject to a Low Pressure area overhead the center canopy section
and therefore will tend to be pulled upward regardless of panel gaps. The affect
these gap sizes have upon overall parasite drag can be measured and assessed
and other than reduction of acoustic noise the impact upon drag and structural
distortion will likely be minimal.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=510989#510989
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: 914 Air Filter |
I have determined that K&N RU0600 air filter fits a 914 turbo inlet properly.
The turbo inlet measures 2.35 (59.69mm).
Rotax specifies P/N 825750. The illustrated parts manual shows filter ID is 2.44
(62mm), filter media height is 3.94 (100mm) and media diameter is 3.54 (90mm).
I purchased this filter and received a K&N RU0800 filter, with the Rotax
part number on the box. Indeed K&N website confirms the above dimensions.
The inlet diameter is too large. If you tighten the clamp enough to secure the
filter, the filter is forced off the turbo.
K&N states All filters are constructed with ultra-strong molded pliable rubber
flanges which absorb vibration and allow for secure attachment and can also be
stretched for up to 1/16 of an inch (1.5mm) to fit in-between sizes.
RU0600 is listed with ID 2.25 (57mm). Media height and diameter are the same as
RU0800.
I purchased RU0600 from a local parts store with hopes that it would stretch and
fit. It fits the 914 turbo perfectly! The clamp holds it in place without distortion
and does not try to force the filter off the turbo.
I have advised Leading Edge Airfoils of my finding and also filed a report with
Rotax.
RU1700 appears to have the same dimension with a 20 deg offset that some need to
fit their aircraft.
Jim Butcher
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=510991#510991
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|