Today's Message Index:
----------------------
 
     1. 07:37 AM - Re: Cabin fresh air exhaust (Area-51)
 
 
 
Message 1
| 					INDEX |  Back to Main INDEX |  
| 					NEXT |  Skip to NEXT Message |  
| 	LIST |  Reply to LIST Regarding this Message |  
| 		SENDER |  Reply to SENDER Regarding this Message |  
  | 
      
      
| Subject:  | Re: Cabin fresh air exhaust | 
      
      
      Its a good question and something that has had a bit of a study in various scenarios,
      yet not anything that in depth.
      
      The attached image provides some indication however the free stream through the
      cabin is fairly slow, and its folding over and back upon itself constantly.
      
      There is no discernible difference in actual ambient pressure to that which is
      external being detected.
      
      Most of the ingress comes from the side vents and center control cutouts. In standard
      trim, on the Classic, the air then finds its way down through the fuel
      tap well, under the tank and then rearward out through the Hstab slots and rudder
      cable tubes. If the original Classic rail wheel port is still available the
      air exits through there as well.
      
      At this stage its unclear whether or not the flap bar slots are acting as ingress
      or egress. I am suspecting the former due to the positioning of the engine
      tail pipe on 181 and the noticeable headaches developing after longer back to
      back flights over more than two days. So my CO detector needs to be switched on
      now that the door seals are working affectively.
      
      Based upon the trajectory and velocity of external free stream air I would expect
      absent door seals to allow air to flow out more rather than in, and I could
      be totally wrong also. A reverse naca vent would assist interior flow velocity
      somewhat as would some way for cabin air to traverse the D panel; this would
      probably have the most affect on uniform airflow through the cabin in flight.
      
      Its a subject that requires more time.
      
      That's all I can offer right now, bit busy with other stuff for a bit.
      
      
      Read this topic online here:
      
      http://forums.matronics.com/viewtopic.php?p=511309#511309
      
      
      Attachments: 
      
      http://forums.matronics.com//files/81558c87_e40c_498a_a3da_b72e26dcb05b_933.jpeg
      
      
 
Other Matronics Email List Services
 
 
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
 
 
-- Please support this service by making your Contribution today! --
  
 |