----------------------------------------------------------
                           Europa-List Digest Archive
                                      ---
                     Total Messages Posted Sun 03/23/25: 3
           ----------------------------------------------------------
 
 
Today's Message Index:
----------------------
 
     1. 11:23 AM - Re: Mono Rubber block height  (dmac7)
     2. 03:35 PM - Re: Mono Rubber block height  (Area-51)
     3. 03:39 PM - Re: Undercarriage Bushes - Raplacement  (Area-51)
 
 
 
________________________________  Message 1  _____________________________________


Time: 11:23:30 AM PST US
Subject: Europa-List: Re: Mono Rubber block height
From: "dmac7" <dmac7@outlook.com>


It seemed to me that the suspension block slowly compresses over time under load
but when I removed it for a few years then put it back in, it expanded back
( from less than 2 1/2" ) to 3". Since then, 3 years of being loaded has it almost
where it was again ( 2 9/16" )
  If one were to have a spare block maybe it would make sense to rotate them every
two years and let them uncompress ?  Did anyone else notice they come back
after being unloaded a few years?


Read this topic online here:

http://forums.matronics.com/viewtopic.php?p=515338#515338


________________________________  Message 2  _____________________________________


Time: 03:35:13 PM PST US
Subject: Europa-List: Re: Mono Rubber block height
From: "Area-51" <goldsteinindustrial@gmail.com>


This is a characteristic of polyurethane.. I use 100SH skateboard wheels on my
forward hangar cradle; after a day or more the wheels get flat spots and expand
true again in about 20 seconds after rolling; the rear cradle uses 70SH wheels
and they compress more if used under the main gear but also expand true almost
immediately.


Read this topic online here:

http://forums.matronics.com/viewtopic.php?p=515339#515339


________________________________  Message 3  _____________________________________


Time: 03:39:28 PM PST US
Subject: Europa-List: Re: Undercarriage Bushes - Raplacement
From: "Area-51" <goldsteinindustrial@gmail.com>


Thanks Jim 

Has anybody tried using Manganese Bronze as a replacement to the Oilite units?


Read this topic online here:

http://forums.matronics.com/viewtopic.php?p=515340#515340


 

-------------------------------------------------------------------------------------
                       Other Matronics Email List Services
-------------------------------------------------------------------------------------
Post A New Message               europa-list@matronics.com
UN/SUBSCRIBE                     http://www.matronics.com/subscription
List FAQ                         http://www.matronics.com/FAQ/Europa-List.htm
Web Forum Interface To Lists     http://forums.matronics.com
Matronics List Wiki              http://wiki.matronics.com
Full Archive Search Engine       http://www.matronics.com/search
7-Day List Browse                http://www.matronics.com/browse/europa-list
Browse Digests                   http://www.matronics.com/digest/europa-list
Browse Other Lists               http://www.matronics.com/browse
Live Online Chat!                http://www.matronics.com/chat
Archive Downloading              http://www.matronics.com/archives
Photo Share                      http://www.matronics.com/photoshare
Other Email Lists                http://www.matronics.com/emaillists
Contributions                    http://www.matronics.com/contribution
-------------------------------------------------------------------------------------

These Email List Services are sponsored solely by Matronics and through the 
generous Contributions of its members.