Today's Message Index:
----------------------
1. 01:06 AM - Re: Zodiac 601HDS with Subaru EA81 (Mickey Coggins)
2. 10:02 AM - Re: Zodiac 601HDS with Subaru EA81 (AI Nut)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Zodiac 601HDS with Subaru EA81 |
--> Homebuilt-List message posted by: Mickey Coggins <mick-matronics@rv8.ch>
> I do not wish to sell the plane in flyable condition, as the legal ramifications
> of being the "manufacturer" are too
> great. Best to piece it out,
Hi Bill,
Before you dismantle it, you may want to read this:
http://www.aviationlawcorp.com/content/liabhomeblt.html
Not sure if this helps you, but it's sad to see a good
airplane moving towards entropy.
Mickey
--
Mickey Coggins
http://www.rv8.ch/
#82007 finishing
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Zodiac 601HDS with Subaru EA81 |
--> Homebuilt-List message posted by: AI Nut <ainut@hiwaay.net>
Gosh, what an *enormous* waste. And all because of fears of
litigation. Thank you, America.
David
Marion Jonker wrote:
>--> Homebuilt-List message posted by: "Marion Jonker" <desertflyer@earthlink.net>
>
>I do not wish to sell the plane in flyable condition, as the legal ramifications
of being the "manufacturer" are too
>great. Best to piece it out,
>The engine is a Subaru EA81 with Ross PSRU (upgraded torque plate and rim weighted
and balanced flywheel)
>
>Air Flow performance fuel injection, dual electronic ignition, with coil combiner,
2 into one stainless steel exhaust,
>oil cooler with thermostat, VW Rabbit radiator with bypass thermostat (BMW)
>
>Engine has approx 300 power hours on it. Burns no oil - blows no oil -- good
compression 150 pounds.
>
>Dyno'd at 102 horsepower at 5200 RPM
>Has Amar/Demuth wooden prop - 2 blade, 72" diameter
>
>If you want to discuss - call me at (951) 927-9640 in Hemet, CA
>
>
>.
>
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|