---------------------------------------------------------- Homebuilt-List Digest Archive --- Total Messages Posted Wed 07/06/05: 2 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 01:06 AM - Re: Zodiac 601HDS with Subaru EA81 (Mickey Coggins) 2. 10:02 AM - Re: Zodiac 601HDS with Subaru EA81 (AI Nut) ________________________________ Message 1 _____________________________________ Time: 01:06:57 AM PST US From: Mickey Coggins Subject: Homebuilt-List: Re: Zodiac 601HDS with Subaru EA81 --> Homebuilt-List message posted by: Mickey Coggins > I do not wish to sell the plane in flyable condition, as the legal ramifications > of being the "manufacturer" are too > great. Best to piece it out, Hi Bill, Before you dismantle it, you may want to read this: http://www.aviationlawcorp.com/content/liabhomeblt.html Not sure if this helps you, but it's sad to see a good airplane moving towards entropy. Mickey -- Mickey Coggins http://www.rv8.ch/ #82007 finishing ________________________________ Message 2 _____________________________________ Time: 10:02:53 AM PST US From: AI Nut Subject: Re: Homebuilt-List: Zodiac 601HDS with Subaru EA81 --> Homebuilt-List message posted by: AI Nut Gosh, what an *enormous* waste. And all because of fears of litigation. Thank you, America. David Marion Jonker wrote: >--> Homebuilt-List message posted by: "Marion Jonker" > >I do not wish to sell the plane in flyable condition, as the legal ramifications of being the "manufacturer" are too >great. Best to piece it out, >The engine is a Subaru EA81 with Ross PSRU (upgraded torque plate and rim weighted and balanced flywheel) > >Air Flow performance fuel injection, dual electronic ignition, with coil combiner, 2 into one stainless steel exhaust, >oil cooler with thermostat, VW Rabbit radiator with bypass thermostat (BMW) > >Engine has approx 300 power hours on it. Burns no oil - blows no oil -- good compression 150 pounds. > >Dyno'd at 102 horsepower at 5200 RPM >Has Amar/Demuth wooden prop - 2 blade, 72" diameter > >If you want to discuss - call me at (951) 927-9640 in Hemet, CA > > >. > > >