Today's Message Index:
----------------------
1. 09:31 AM - Jabiru 2200 Solid Lifter in Avid Heavy Hauler, also @ Kitfox (moosepileit)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Jabiru 2200 Solid Lifter in Avid Heavy Hauler, also @ Kitfox |
List,
There is an Avid 2005 cert'd Heavy Hauler on Barnstormers. The engine is a Jab
2200 of unknown S/N and S/B compliance w/ 125 hours. The cruise at 4GPH is only
65 MPH, looks like a 2 blade warp drive prop.
This seems a good 10 MPH slow and no where near the cruise step.
The inlets look like the smaller un modded size, though basic question about Oil
Temp and CHT got a "no problems" response.
At 16K it seems like a good deal- has a panel radio, Narco Trans/Mode C, etc- I
know at 6'1 and 230# I'm a tight squeeze- I just fit in a Kitfox IV w/ some stick/leg
bumping, but the sig. other is a tiny 5'4 and 115#.
I've read all the Jabiru S/Bs, the AD note, etc. It has a Bing Carb, but don't
know if it's 32 or 40MM- the Rotec TBI looks like the thing to swap to down the
road. I don't mind a new prop test phase if there is a better one out there-
would like to goto ELSA, so would like to keep it fixed pitch.
Don't want to spend 6 grand and have to tear down the motor to update it, but I'd
take the courses to do the maint. on it as a LSA.
Suggestions, hints, gotchas?
Thanks in advance
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=283791#283791
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|