Today's Message Index:
----------------------
1. 02:49 PM - Re: Float Level (RONAL SMITH)
2. 04:44 PM - Re: Re: Float Level (gelco)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Lynn,
I didn't measure the 240 main jet before I put it in, but here are
measurements for the 220 main jet - .078", drill no. 47,
and for the spare 245 main jet - .089", drill no. 43. You could
extrapolate between these two numbers to get a size for the 240 main
jet. I would error on the smaller size, otherwise you could be running
rich. Hope this helps.
Ron Smith, KF IV with Jabiru 2200A engine.
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
please remove Gaylord Clark from jabiru engine list. GC
----- Original Message -----
From: RONAL SMITH
To: jabiruengine-list@matronics.com
Sent: Wednesday, May 07, 2008 2:45 PM
Subject: JabiruEngine-List: Re: Float Level
Lynn,
I didn't measure the 240 main jet before I put it in, but here are
measurements for the 220 main jet - .078", drill no. 47,
and for the spare 245 main jet - .089", drill no. 43. You could
extrapolate between these two numbers to get a size for the 240 main
jet. I would error on the smaller size, otherwise you could be running
rich. Hope this helps.
Ron Smith, KF IV with Jabiru 2200A engine.
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|