Today's Message Index:
----------------------
1. 08:51 AM - Re: EGT Probes (ianwilson2)
2. 09:09 AM - Re: Re: EGT Probes (Lynn Matteson)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Thanks Bob, SW and especially Lynn for the washer tip. Do I need to get the tip
of the probe in the middle of the pipe? Because if so, I need around 1/2 inch
of washers to achieve this on my engine? That's quite a lot of washers!
Ian
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p 4234#204234
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
I only put 4 thin washers on each probe...about 1/8" worth. This
didn't center the probe, but got it away from the far side of the pipe.
Lynn Matteson
Kitfox IV Speedster
Jabiru 2200, 562 hrs...engine assembled and back in the plane;
waiting for new ignition system
Status: "Condition grounded, but determined to try." (Pink
Floyd..."Learning to Fly")
On Sep 14, 2008, at 11:50 AM, ianwilson2 wrote:
> <ianwilson2@hotmail.com>
>
> Thanks Bob, SW and especially Lynn for the washer tip. Do I need
> to get the tip of the probe in the middle of the pipe? Because if
> so, I need around 1/2 inch of washers to achieve this on my
> engine? That's quite a lot of washers!
>
> Ian
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p 4234#204234
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|