Today's Message Index:
----------------------
1. 09:21 AM - Re: Found it at last-Coil feed wires not crimped on (Chuck Deiterich)
2. 01:43 PM - Finally got the EIS problem solved (Lynn Matteson)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Found it at last-Coil feed wires not crimped on |
Clive,
I noticed the harness loom tubing had melted at the connection from the
alternator. I think the connectors I used were not compatible with the
ones from the alternator. I cut off the connectors and soldered the
wires, everything is "cool" now. This had been a common problem in the
past.
Chuck D.
N701TX
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Finally got the EIS problem solved |
I finally got the EIS 4000 to report accurate data, without hopping
all over the screen, I installed a Radio Shack 273-105 ferrite filter
(as suggested by Sandy at Grand Rapids Tech) around the input wire
bundle, and that seems to have cured it. After installing the filter,
the thing acted up once during taxi, but never after that....in .4
hrs of flying. I have another filter to install on the EGT and CHT
probe extensions, but I may not need to do that....we'll see.
Lynn Matteson
Kitfox IV Speedster
Jabiru 2200, 583hrs
Sensenich 62x46
flying again (21 hrs) after rebuild, and new Electroair direct-fire
ignition system
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|