JabiruEngine-List Digest Archive
Tue 04/13/10 |
Total Messages Posted: 1 |
Today's Message Index:
----------------------
1. 02:08 PM - (Robert Rivard)
Message 1
INDEX Back to Main INDEX NEXT Skip to NEXT Message LIST Reply to LIST Regarding this Message SENDER Reply to SENDER Regarding this Message
Time: 02:08:52 PM PST US
From: Robert Rivard <bw12345@sbcglobal.net>
Any advice on setting the valve clearance on a 2200 solid lifter engine. I
followed the manual by rotating the prop 360 degrees from when the valve wa
s fully depressed and set at .010.I did all the valves following this proce
edure. Then I rechecked by checking the clearance by rotating engine till o
ne valve was depressed then checked the other. The valve which was set at .
010 now has a clearance of .012 in this position. This was true of all the
valves when I checked using the second method..Which is correct?-
BOB
Other Matronics Email List Services
Post A New Message jabiruengine-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/JabiruEngine-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com 7-Day List Browse http://www.matronics.com/browse/jabiruengine-list Browse JabiruEngine-List Digests http://www.matronics.com/digest/jabiruengine-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.