Today's Message Index:
----------------------
1. 07:06 AM - Re: Installing EGT probes on 3300 (Larry and Dee Pritchard)
2. 03:46 PM - (uthai khewraxsawong)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Installing EGT probes on 3300 |
On my 3300 I measured down 4 inches and was into the collector tube ,
so I put my EGT probes down only 2.5 inches down. After a short time I
moved #2 probe to 5 inches down on # 6 so that I had two operating
probes on # 6. The two readings on #6 were the same. I then moves #2
back to its proper location and have not looked back. I expected to see
a difference but in fact I saw none. If you use the 4 inch distance on
all six cylinders, the readings for 1,2,3, and 4 will be from mixed
exhaust gases. Larry P.
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|