Today's Message Index:
----------------------
 
     1. 06:14 AM - Re: Fuel & EGT's (Tex Mantell)
     2. 07:48 AM - reinstalling cylinders (AirEupora)
 
 
 

Message 1


					INDEX
 Back to Main INDEX
					NEXT
 Skip to NEXT Message
	LIST
 Reply to LIST Regarding this Message
		SENDER
 Reply to SENDER Regarding this Message

      
      
Time: 
06:14:45 AM PST US
From: 
"Tex Mantell" <wb2ssj@rochester.rr.com>
Subject: 
Re: Fuel & EGT's
      
      My carb had the port to use. Small brass screw on bottom of carb.
      
      From: Peter Thomson 
      Sent: Monday, September 1, 2014 10:23 AM
      Subject: Re: JabiruEngine-List: Fuel & EGT's
      
      Tex
      
      With the Hackman kit, did you have to drill a port in the Bing? The Bing 
      on my J2200 does not have an existing port to use.
      
      Peter
      
      

Message 2


					INDEX
 Back to Main INDEX
				PREVIOUS
 Skip to PREVIOUS Message
					NEXT
 Skip to NEXT Message
	LIST
 Reply to LIST Regarding this Message
		SENDER
 Reply to SENDER Regarding this Message

      
      
Time: 
07:48:02 AM PST US
Subject: 
reinstalling cylinders
From: 
"AirEupora" <AirEupora@sbcglobal.net>
      
      
      I pulled #2 and #4 cylinder off as I had a loss of compression because of over
      heating. 
      
      I'm reading JEM0001-4 Overhaul Manual and on page 109 of 197, section 7.3.1, it
      states "Ensure the gaps are within the limits given in Table 12. 0.50  0.60mm
      is typical in a 97.60mm bore though the gap will vary depending on the exact
      size of the barrel."
      
      but when you go to Table 12 it give 'N/A" under the Top End Inspection and 0.44
      -1.20 under the New Clearances.
      
      Any idea which I should follow?
      
      Rick Stockton
       N120EJ Europa
      3300L 47 hours
      
      
      Read this topic online here:
      
      http://forums.matronics.com/viewtopic.php?p=429840#429840
      
      








Other Matronics Email List Services




Post A New Message
  
jabiruengine-list@matronics.com
UN/SUBSCRIBE
  
http://www.matronics.com/subscription
List FAQ
  
http://www.matronics.com/FAQ/JabiruEngine-List.htm
Web Forum Interface To Lists
  
http://forums.matronics.com
Matronics List Wiki
  
http://wiki.matronics.com
7-Day List Browse
  
http://www.matronics.com/browse/jabiruengine-list
Browse JabiruEngine-List Digests
  
http://www.matronics.com/digest/jabiruengine-list
Browse Other Lists
  
http://www.matronics.com/browse
Live Online Chat!
  
http://www.matronics.com/chat
Archive Downloading
  
http://www.matronics.com/archives
Photo Share
  
http://www.matronics.com/photoshare
Other Email Lists
  
http://www.matronics.com/emaillists
Contributions
  
http://www.matronics.com/contribution









These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.




-- Please support this service by making your Contribution today! --