---------------------------------------------------------- KIS-List Digest Archive --- Total Messages Posted Fri 07/04/14: 3 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 05:01 AM - Re: g3x pictures (fasilpereira) 2. 09:00 AM - KIS TR-4 Control Surfaces Deflections (fasilpereira) 3. 09:12 AM - Re: N819PR now has 1000hrs (mark_trickel) ________________________________ Message 1 _____________________________________ Time: 05:01:18 AM PST US Subject: KIS-List: Re: g3x pictures From: "fasilpereira" Hi Bob, You could upload the pictures to the Matronics Forum. There is a link to "Add an attachment" when you select Post a reply. If you want you can send the pictures to my email and I'll upload it to the Forum. Thanks, Fabricio -------- Fabricio Pereira Engineer / Pilot Read this topic online here: http://forums.matronics.com/viewtopic.php?p=426068#426068 ________________________________ Message 2 _____________________________________ Time: 09:00:02 AM PST US Subject: KIS-List: KIS TR-4 Control Surfaces Deflections From: "fasilpereira" I'm working on my ailerons mass balance now. I had to build new ones since the ones that came with my partially built kit had the bolt holes enlarged by the previous builder, making it too weak for my standards... After building new ones and using the same holes on the ailerons, I've got about 7.5 deg DN and 17.5 Deg UP on my ailerons. I remember to read on the builders manual that the aileron deflection is usually limited to 8 to 9 DN and to 13 to 14 UP and that this should be sufficient. Based on this, I think that my aileron DN deflection is not enough and that I have margin on the UP deflection. Now I'm planning to rework the mass balance in order to correct this issue. I'd like to know what are the typical control surfaces deflections (Ailerons, Flap, Elevator, Rudder and Trim tabs) on the KIS TR-4 so that I can compare my measurements. Thanks, Fabricio -------- Fabricio Pereira Engineer / Pilot Read this topic online here: http://forums.matronics.com/viewtopic.php?p=426078#426078 ________________________________ Message 3 _____________________________________ Time: 09:12:07 AM PST US Subject: KIS-List: Re: N819PR now has 1000hrs From: "mark_trickel" Galin, Congratulations on passing the 1000 hour mark. Two other titles you deserve are: the most hours over open water, and the most landings in foreign countries. I wish you many more happy flying hours in your Cool Cruiser. Mark T. Read this topic online here: http://forums.matronics.com/viewtopic.php?p=426079#426079 ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message kis-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/KIS-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/kis-list Browse Digests http://www.matronics.com/digest/kis-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.