Today's Message Index:
----------------------
1. 11:05 AM - Re: gear leg gap (Robert Reed)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: gear leg gap |
I have seen them used before but will have to take the flex into considerat
ion that is a given.
Bob
From: Alfred Rosa <fredorosa@gmail.com>
To: "kis-list@matronics.com" <kis-list@matronics.com>
Sent: Monday, May 9, 2016 6:54 PM
Subject: Re: KIS-List: gear leg gap
Nice job Bob. =C2-I don't know the feasibility of screwing it stationary
to the bottom since the gear will flex dramatically. =C2-Maybe best to le
ave them off.=C2-Al
Sent from my iPhone
On May 9, 2016, at 5:44 PM, Robert Reed <robertr237@att.net> wrote:
Al,
Since I have not finished my project yet I hesitate to say anything but I d
id fabricate a gear fairing using foam and fiberglass.=C2- I can show you
the installed photos yet but you can see my steps and what the finished fa
irings will look like on my web page.=C2- The only thing remaining is to
split the fairings for installation and add the screws.=C2- (OH and paint
which seems to be my damnation.)
(LandingGearFairing.html)
Hope this helps.
Bob Reed
From: Alfred Rosa <fredorosa@gmail.com>
To: kisbuilders <kis-list@matronics.com>
Sent: Monday, May 9, 2016 3:58 PM
Subject: KIS-List: gear leg gap
Has anyone done anything about the gap where the gear leg goes through the
wing fairing?
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|