---------------------------------------------------------- KIS-List Digest Archive --- Total Messages Posted Tue 07/18/23: 3 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 12:52 PM - DYNON SkyView Roll Servo?? (GalinHdz) 2. 01:45 PM - Re: DYNON SkyView Roll Servo?? (Robert Reed) 3. 01:48 PM - Re: DYNON SkyView Roll Servo?? (Robert Reed) ________________________________ Message 1 _____________________________________ Time: 12:52:48 PM PST US Subject: KIS-List: DYNON SkyView Roll Servo?? From: "GalinHdz" What size DYNON roll servo have any of you used for the KIS4 and where did you mount it? Read this topic online here: http://forums.matronics.com/viewtopic.php?p=511116#511116 ________________________________ Message 2 _____________________________________ Time: 01:45:50 PM PST US From: Robert Reed Subject: Re: KIS-List: DYNON SkyView Roll Servo?? Galin I used the smallest of the three available after determining that the moveme nt was more than adequate. I installed it on a mount under the pilot seat o n ground plate I had originally sized for the mount. The difference between y our setup though is that you have the dual stick vs my single center stick. Bob Reed Sent from my iPhone > On Jul 18, 2023, at 2:52 PM, GalinHdz wrote: > > > What size DYNON roll servo have any of you used for the KIS4 and where did you mount it? > > > > > Read this topic online here: > > http://forums.matronics.com/viewtopic.php?p=511116#511116 > > > > > > ========================== ========= ========================== ========= ========================== ========= ========================== ========= ========================== ========= > > > ________________________________ Message 3 _____________________________________ Time: 01:48:57 PM PST US From: Robert Reed Subject: Re: KIS-List: DYNON SkyView Roll Servo?? Galin I used the smallest of the three available after determining that the moveme nt was more than adequate. I installed it on a mount under the pilot seat o n ground plate I had originally sized for the mount. The difference between y our setup though is that you have the dual stick vs my single center stick. Bob Reed Sent from my iPhone > On Jul 18, 2023, at 2:52 PM, GalinHdz wrote: > > > What size DYNON roll servo have any of you used for the KIS4 and where did you mount it? > > > > > Read this topic online here: > > http://forums.matronics.com/viewtopic.php?p=511116#511116 > > > > > > ========================== ========= ========================== ========= ========================== ========= ========================== ========= ========================== ========= > > > ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message kis-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/KIS-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/kis-list Browse Digests http://www.matronics.com/digest/kis-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.