Today's Message Index:
----------------------
1. 02:56 AM - Tailwheel steering setup (Dave G)
2. 04:40 AM - Re: the flaperon dilema (larry huntley)
3. 03:47 PM - EGT problems resolved!! (Rical26)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Tailwheel steering setup |
Lost a steering spring last night, scary!! I am looking for pictures and
advice on the setup so I can optimize the setup when I assemble new
parts.
On my previous attempt I used two stretch springs that were on the
aircraft when I got it, I notice most of the setups I have seen use
compression springs.
Anyway, I want to do it the best way I can so I'll take whatever advise
I can get, thanks.
Dave Goddard
KF IV 1050 / 582 / Warp
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: the flaperon dilema |
Probably best to just drive out and pick it up yourself. Larry-----
Original Message -----
From: Malcolm Brubaker
To: kitfox-list@matronics.com
Sent: Thursday, September 09, 2010 9:12 PM
Subject: Kitfox-List: the flaperon dilema
what would i cost to ship a 12 ft flaperon? say aprox 300 miles could
you cut in half and splice it afterwords?
that would ship ups or fedex at a great savings what is a good
prise for one anyway? mal
Malcolm Brubaker
Michigan Sport
Pilot Repair
LSRM-A, PPC, WS
(989)513-3022
-------------------------------------------------------------------------
-----
From: jridgway <jridgway@academicplanet.com>
To: kitfox-list@matronics.com
Sent: Wed, September 8, 2010 8:34:41 PM
Subject: Kitfox-List: Re: Jabiru cooling questions
<jridgway@academicplanet.com>
Use the Jab cooling system.
Read this topic online here:
http://forums.matronicnbsp;
-------------------------------------------------------------------------
-----
Checked by AVG - www.avg.com
09/09/10 02:34:00
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | EGT problems resolved!! |
Hi all, FINALLY I resolved my EGT problem!!! After many weeks of frustrations and
trying just about everything,with all your suggestions and ideas. The problems
was,I have a stratomaster gauge and the EGT senders were programmed for K-type
and the senders were J-type (old) so when I changed my setting to the right
type....temperature when from 1225 to 1055!
Now my EGT temp is just about perfect and everything is good
Thanks to all of you for your suggestions
Richard
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=312077#312077
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|