Today's Message Index:
----------------------
1. 04:51 PM - Final Assembly (Jim Gilliatt)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
I have a Series 7 near completion; everything is covered and
painted.It's has an IO240, and a manual trim tab configuration; which is
the point of this message.
I am at the point where I am trying to mount my horizontal stabilizer,
and the push-pull cable that controls the trim tabs is in the way of the
slot for the horizontal stabilizer.It appears that I have attached the
bracket that holds the rear end of the push-pull cable too far forward,
and as a result it won't move high enough to go over the stabilizer.The
manual is very vague on this configuration, and at this moment I cannot
remember what sort of logic I used to place the bracket where I did.
It appears that if I move the bracket rearward, it might do the trick.If
someone could give me a measurement as to where to put it (no jokes), or
some advice as a way to figure it out, it would be helpful.
Thanks,
Jim Gilliatt
West Greenwich, RI
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|