Today's Message Index:
----------------------
1. 05:39 AM - Classic IV Firewall (PMorel)
2. 08:19 AM - Re: Classic IV Firewall (Lowell Fitt)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Classic IV Firewall |
I'm building a Classic IV and was hoping someone has the dimensions of the lower
firewall panels. I'll be installing a Rotax 912 and I have the cutout for the
starter for the panel. I only need the dimensions for the center and ether left
or right panel since I assume they are the same size. Thanks
Paul
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Classic IV Firewall |
Paul,
The dimensions of what I would call the foot wells are : top forward
bend begins right below the side engine mount and is 4" to the downward
bend. The lower section runs from that bend 10-3/8" to the bottom bend.
This results is a foot well that extends forward of the plane of the
firewall slightly under 4" at the top, tapering to zero at the bottom.
The extension that fits over and around the bottom front of the fuselage
is 1-3/8" top to bend and then extends aft under the fuselage 5-3/8".
The gap between the foot wells is 6" wide.
If this sounds confusing, drop another note.
Lowell
From: PMorel
Sent: Saturday, November 12, 2011 5:36 AM
Subject: Kitfox-List: Classic IV Firewall
I'm building a Classic IV and was hoping someone has the dimensions of
the lower firewall panels. I'll be installing a Rotax 912 and I have
the cutout for the starter for the panel. I only need the dimensions
for the center and ether left or right panel since I assume they are the
same size. Thanks
Paul
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|