---------------------------------------------------------- Kitfox-List Digest Archive --- Total Messages Posted Wed 05/28/14: 1 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 02:48 PM - Re: 582 breakin (Patrick Reilly) ________________________________ Message 1 _____________________________________ Time: 02:48:27 PM PST US Subject: Re: Kitfox-List: 582 breakin From: Patrick Reilly Jared, I just reinstalled my 582 with a new GA 72" Warp Drive prop. I've got it set at 12 1/2 degrees of pitch. That is what I had on my old Warp drive prop. I'm idling down around 1600 rpm and max static on the ground is 5500 rpm with the engine at full operating temp. It would wind up to 5700 rpm before it warmed to full operating temp, say down around 110 degree water temp. I'm not sure what static rpm should be on this set up. I looked at an old CPS catalog which used to be the Rotax bible before they were bought out. But, couldn't find reference to static rpm. Can anybody verify what static rpm should be? Jared's 4300 rpm static sounds low. You don't mention prop specs Jared. They would help. Pat Reilly Mod 3 582 Rebuilt Rockford, IL On Sun, May 18, 2014 at 9:33 PM, jareds wrote: > > Greetings listers. Hope there are still a few out there monitoring the > list. > Finally got the 582 running again. > Going through the breakin. switched from a clutch gearbox to a straight c > (no clutches) > Havnt switched prop pitch since before engine rebuild. > 4300 is top rpm tied down on ground. > 2500 is idle > Temps got up to about 190 before i interupted them to let it cool down. > I was using green anti freeze so will drain and put aluminum type in at > 5050. > > 1. IN flight i used to get 6000 rpm with same pitch. Will my pitch be ok > prior to test flight? > 2. Is 2500 too high for static prop and gearbox? > 3. Do any of you remember getting higher rpms during ground breakin? > 4. Should i change fuel pumps after 2 years of fox sitting? Ran good > during breakin? > 5. Temps have always been a problem... i lowered radiator long ago and > built a little scoop for it and got along ok but not great. Always had to > be careful. Any new suggestions in 10 years or more?? > > Thanks > > Jared > > -- Pat Reilly Mod 3 582 Rebuild Rockford,IL ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message kitfox-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/Kitfox-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/kitfox-list Browse Digests http://www.matronics.com/digest/kitfox-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.