Today's Message Index:
----------------------
1. 06:48 PM - Re: kitfox IV speedster jury strut questionkitfox IV speedster jury strut question (Jack Bell)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: kitfox IV speedster jury strut questionkitfox IV speedster |
jury strut question
Thanks for the response. I think I have a way to make them fit, have
some 1" adel clamps on order to fit to the lift struts. If they were
the round jury struts, I could "tweak" them into shape, but these are
streamlined, and powder coated to boot, so I have to make the plane fit
them, and the supplied clamps, don't. I did find the lift struts were
not quite straight, and that helps a bit. There's always something else
to work on while parts are on their way!
Jack
Austin, TX
Avid Catalina N92KL (flying)
Osprey 2 N52JB (project on hold)
Kitfox IV speedster (project underway)
>>
*Hi Jack I built my Kitfox 3 with 4 wings in 1993. The jury strut
fittings were a little off too. I think if the don't push or pull the
wing braces you are ok. Cheers, Kirby Cramer Kitfox 4 NSI Subaru, N45KC
Vans RV7A O-360, N445KC FAA Experimental Aircraft Repairman EAA Life
Member Fallbrook, CA YouTube: Cramer's Classic Cycles*
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|