Today's Message Index:
----------------------
1. 12:48 PM - Re: warp drive prop extension (Kirby, Dennis CTR USAF AFMC MDA/AL)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | re: warp drive prop extension |
<< I've seen a prop extension used on the Kolb with the warp drive prop
on the 912, >>
Lucien -
As Scott "icrashrc" suggested, Travis at Kolb recommended I go to Sabre
Mfg (Granbury, TX) for a prop extension for my 912. I purchased a
3-inch extension for my Powerfin for $320 in March, 07. CNC machined
from billet aluminum, it's practically a work of art. I have been
totally pleased with it, since I installed it. Noticeable decrease in
cabin noise, in flight.
I suspect the type of prop you have does not matter. What is important
is you tell them it's for a 912. It's the 912's prop flange and hole
spacing that dictates the design of the prop extension. Good luck!
Dennis Kirby
Mark-3, 912ul, Powerfin-72
Cedar Crest, NM
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|