---------------------------------------------------------- Kolb-List Digest Archive --- Total Messages Posted Sun 09/04/11: 9 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 06:06 AM - Re: Battery location (Jimmy Young) 2. 07:11 AM - Re: Re: Battery location (Andy and Sheila Slinkard) 3. 09:58 AM - Re: Strobe Light (Ron @ KFHU) 4. 10:14 AM - Re: Strobe Light (Michael Welch) 5. 12:35 PM - Re: Strobe Light (Larry Cottrell) 6. 01:14 PM - Re: Strobe Light (Ron @ KFHU) 7. 03:10 PM - Re: Strobe Light (Renee) 8. 05:46 PM - Re: Strobe Light (Ron @ KFHU) 9. 09:18 PM - Re: Strobe Light (Richard Pike) ________________________________ Message 1 _____________________________________ Time: 06:06:28 AM PST US Subject: Kolb-List: Re: Battery location From: "Jimmy Young" > Jimmy, I am building a Firestar II with an HKS engine. Am concerned about > weight and balance. I weigh 170 lbs. I am installing a 4.5 lb., 6 inch > tail wheel . Have a 15 gallon integrated fuel tank so I may have an aft cg > problem. What size battery did you use and is your solenoid close to the > battery? Do you have a starter solenoid as well continuous operation > solenoid? Andy, I don't remember the size of the battery, but it's a typical motorcycle battery. I do have both a continuous-duty solenoid located behind my seat at my elect. service panel and a starter solenoid that came with the engine. I have a custom tailwheel I built that is heavier than the stock TW, but again I don't know what it weighs. I assume the original builder of my Kolb may have been a lighter weight fellow & been concerned with the same W&B issues you have, and thus the nosecone battery location. I wish I weighed 170, but am more like 225. You may want to consider adding the tailwheel struts others have done on the Kolbs. My lower vert. stblzr. assembly broke due to the side loads and the struts really help it out. Do an archive search & you will find them. Where are you located? Hope this helps, keep up the good work. -------- Jimmy Young Missouri City, TX Kolb FS II/HKS 700 Read this topic online here: http://forums.matronics.com/viewtopic.php?p=351373#351373 ________________________________ Message 2 _____________________________________ Time: 07:11:16 AM PST US From: "Andy and Sheila Slinkard" Subject: Re: Kolb-List: Re: Battery location Jimmy and other Kolbers, we are located out west in Washington state farming and ranching, WN31 is my airstrip locater. I have built several airplanes; recovered Champs and Stinsons, built Glasair SH-1 in '85, Benson Gyros, and 1 Jerry Barnett JB-42 Gyro. I met John Hauk and Larry Cottrell this spring at the rock house- nice people. Love to hear from other Kolbers, all welcome. Thanks for the information and hope to meet you in the future. Andy ----- Original Message ----- From: "Jimmy Young" Sent: Sunday, September 04, 2011 6:03 AM Subject: Kolb-List: Re: Battery location > > >> Jimmy, I am building a Firestar II with an HKS engine. Am concerned about >> weight and balance. I weigh 170 lbs. I am installing a 4.5 lb., 6 inch >> tail wheel . Have a 15 gallon integrated fuel tank so I may have an aft >> cg >> problem. What size battery did you use and is your solenoid close to the >> battery? Do you have a starter solenoid as well continuous operation >> solenoid? > > > Andy, I don't remember the size of the battery, but it's a typical > motorcycle battery. I do have both a continuous-duty solenoid located > behind my seat at my elect. service panel and a starter solenoid that came > with the engine. I have a custom tailwheel I built that is heavier than > the stock TW, but again I don't know what it weighs. > > I assume the original builder of my Kolb may have been a lighter weight > fellow & been concerned with the same W&B issues you have, and thus the > nosecone battery location. I wish I weighed 170, but am more like 225. > > You may want to consider adding the tailwheel struts others have done on > the Kolbs. My lower vert. stblzr. assembly broke due to the side loads and > the struts really help it out. Do an archive search & you will find them. > > Where are you located? Hope this helps, keep up the good work. > > -------- > Jimmy Young > Missouri City, TX > Kolb FS II/HKS 700 > > > Read this topic online here: > > http://forums.matronics.com/viewtopic.php?p=351373#351373 > > > ________________________________ Message 3 _____________________________________ Time: 09:58:27 AM PST US From: "Ron @ KFHU" Subject: Re: Kolb-List: Strobe Light I am (guessing) pretty sure as I see no filament and I run an ohm meter across the prongs and it showed nothing. Those things do have a filament right? its not some fancy gas plasma gizmo. I don't remember what it looked like before I had it mounted kinda expected it to last at least 10 years or so. I'll try to upload a close up photo of it a bit later as it is sitting by the other computer. I can still cancel my order with aircraft spruce it ain't shipped yet. Ron @ KFHU ---- Richard Girard wrote: ============ Ron, From what I've learned, the fragile element in a strobe system is usually the capacitor(s) used for the rapid charging and discharging. Are you absolutely sure it's the bulb? Rick Girard On Sat, Sep 3, 2011 at 8:55 PM, Ron @ KFHU wrote: > > Anyone got any experience with the FS 4400 strobe? > > I bought one years ago finally had installed, the bulb lasted 5 hours at > best estimate. I can't find any data on bulb longevity. It could be that the > long storage and jostling around may be a factor in such a short life > expectancy, but at 40 bucks including shipping it$ not looking like a good > deal long term. > > Ron @ KFHU > > -- Zulu Delta Mk IIIC Thanks, Homer GBYM It isn't necessary to have relatives in Kansas City in order to be unhappy. - Groucho Marx -- kugelair.com ________________________________ Message 4 _____________________________________ Time: 10:14:59 AM PST US From: Michael Welch Subject: Re: Kolb-List: Strobe Light Ron, Yes, it is supposed to have a filament. I have two strobe units (left wing tip and right). Good one has the filament, burned out one doesn't. Luckily, I have two sets of Nav Lights (an extra set), so I swapped flash strobe bulbs. Now they both work. Mike Welch ________________________________ Message 5 _____________________________________ Time: 12:35:11 PM PST US From: "Larry Cottrell" Subject: Re: Kolb-List: Strobe Light You guy's should be talking to Dick Kuntzleman. I have a pair of his that has been in use for 5 years with no problems. Larry Note: If you forward this email, please delete the forwarding history, which includes my email address. ----- Original Message ----- From: Michael Welch To: kolb-list@matronics.com Sent: Sunday, September 04, 2011 11:12 AM Subject: Re: Kolb-List: Strobe Light Ron, Yes, it is supposed to have a filament. I have two strobe units (left wing tip and right). Good one has the filament, burned out one doesn't. Luckily, I have two sets of Nav Lights (an extra set), so I swapped flash strobe bulbs. Now they both work. Mike Welch ________________________________ Message 6 _____________________________________ Time: 01:14:29 PM PST US From: "Ron @ KFHU" Subject: Re: Kolb-List: Strobe Light Okay that's good, now if I can figure out who else sales these bulbs I guess I can get it for a fraction of the cost. I a, wondering about the probability of this being a custom bulb just for the FS1440. I am gonna load up a photo and if someone recognizes this as a generic bulb for 5 bucks I'll owe him her a beer. I'd prefer a her but you know how it is............. Ron @ KFHU ---- Michael Welch wrote: ============ Ron, Yes, it is supposed to have a filament. I have two strobe units (left wing tip and right). Good one has the filament, burned out one doesn't. Luckily, I have two sets of Nav Lights (an extra set), so I swapped flash strobe bulbs. Now they both work. Mike Welch -- kugelair.com ________________________________ Message 7 _____________________________________ Time: 03:10:53 PM PST US From: Renee Subject: Re: Kolb-List: Strobe Light I prefer wine coolers. :) Renee Bas spellong blaned on ophone :) On Sep 4, 2011, at 1:11 PM, "Ron @ KFHU" wrote: > Okay that's good, now if I can figure out who else sales these bulbs I guess I can get it for a fraction of the cost. I a, wondering about the probability of this being a custom bulb just for the FS1440. > I am gonna load up a photo and if someone recognizes this as a generic bulb for 5 bucks I'll owe him her a beer. I'd prefer a her but you know how it is............. > > Ron @ KFHU > > > ---- Michael Welch wrote: > > ============ > > Ron, > > Yes, it is supposed to have a filament. I have two strobe units (left wing tip and right). Good one has the filament, burned out one > doesn't. Luckily, I have two sets of Nav Lights (an extra set), so I swapped flash strobe bulbs. Now they both work. > > Mike Welch > > > > > > -- > kugelair.com > <001.JPG> > <002.JPG> > <003.JPG> > <004.JPG> ________________________________ Message 8 _____________________________________ Time: 05:46:36 PM PST US From: "Ron @ KFHU" Subject: Re: Kolb-List: Strobe Light First you gotta come up with a bulb, smart stuff. Ron @ KFHU ======================================== ---- Renee wrote: ============ I prefer wine coolers. :) Renee Bas spellong blaned on ophone :) On Sep 4, 2011, at 1:11 PM, "Ron @ KFHU" wrote: > Okay that's good, now if I can figure out who else sales these bulbs I guess I can get it for a fraction of the cost. I a, wondering about the probability of this being a custom bulb just for the FS1440. > I am gonna load up a photo and if someone recognizes this as a generic bulb for 5 bucks I'll owe him her a beer. I'd prefer a her but you know how it is............. > > Ron @ KFHU > > > ---- Michael Welch wrote: > > ============ > > Ron, > > Yes, it is supposed to have a filament. I have two strobe units (left wing tip and right). Good one has the filament, burned out one > doesn't. Luckily, I have two sets of Nav Lights (an extra set), so I swapped flash strobe bulbs. Now they both work. > > Mike Welch > > > > > > -- > kugelair.com > <001.JPG> > <002.JPG> > <003.JPG> > <004.JPG> -- kugelair.com ________________________________ Message 9 _____________________________________ Time: 09:18:10 PM PST US Subject: Kolb-List: Re: Strobe Light From: "Richard Pike" Please do not post un-resized pictures. It makes it almost impossible to read the posts without scrolling back and forth, resizing the page, and other hoop-jumpings that would be unnecessary if the pictures were simply resized. Thank you Richard Pike MKIII N420P (420ldPoops) -------- Now faith is the substance of things hoped for, the evidence of things not seen. Hebrews 11:1 Read this topic online here: http://forums.matronics.com/viewtopic.php?p=351443#351443 ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message kolb-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/Kolb-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/kolb-list Browse Digests http://www.matronics.com/digest/kolb-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.