Today's Message Index:
----------------------
1. 05:02 AM - landing gear (mojavjoe@comcast.net)
2. 09:31 AM - Hinge sizes...... (Nick Cassara)
3. 09:55 AM - Re: landing gear (Rex Rodebush)
4. 06:51 PM - Re: Oil injection? (pipercolt)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
I'm trying to attach my aluminum gear leg to the axle fitting but it=C2-w
ill only go a half inch or so into the fitting.=C2- I'm assuming that I n
eed to heat the fitting to expand it but before I do=C2- would someone pl
ease advise me.
=C2-
thanks
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Hinge sizes...... |
Hello Kolbers,
When I bought my kit, it came from a third party. The kit was taken back to
Kolb and Travis checked it over and then handle the packing and shipping. Of
course Travis did a great job and the kit made it to Alaska in perfect
shape. At the time Travis mentioned that where were extra materials that
came in with the kit. It turns out that there were extra hinges in the kit,
of the wrong size. It is pretty easy to mix up the sizes, and my direction
where not clear on what the right size was. Travis was in route to Oshkosh,
but I was able to get all call through to him and get straightened out.
Thanks for the help Richard!
Ailerons and Flaps use MS20257-5,
Rudder and Elevators use MS20257-2
Nick Cassara
Palmer, Alaska
Message 3
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: landing gear |
I installed the steel legs on my Xtra. Had to use a flapper wheel with extensions
to slowly work the legs into the leg tubes.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=427374#427374
Message 4
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Oil injection? |
Thanks Jim for your replies.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=427387#427387
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|