Today's Message Index:
----------------------
1. 06:42 AM - Re: Building Brake Bleeder...ABS vs PCV (william sullivan)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Building Brake Bleeder...ABS vs PCV |
You could try it, but a couple of cautions. Check the ABS, and make sure brake
fluid doesn't dissolve it or soften it. Keep your air pressure low- ABS is
usually used for drain lines, and I don't know what suction will do. I think
it will work. I watched Richard Pike's link to the Harbor Freight bleeder, and
I think you ought to order one.
Bill Sullivan
Hello Kolbers,
The November 2016 issue of Kit Plane magazine has an article
about building a Homemade Compressed Air Brake Bleeder
which seems to this neophyte brake installer like a good
idea. The directions call for building the reservoir out of
3 PVC pipe. Without traveling 50 plus mile, all that
is available locally is 3 ABS. I wonder if there is a
plastics expert in the group that can tell me of a reason
not to build this pressurized reservoir out of ABS pipe?
Thanks for your thoughts,
Nick Cassara
-Matt
Dralle, List Admin.
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|