Today's Message Index:
----------------------
1. 03:41 PM - Start problem (Delfindriver)
2. 03:59 PM - (schwartzcompany@att.net)
3. 04:10 PM - Re: (William Geipel)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
I'm still looking for help on my start problem on R model. In brief, all
wires going to start box Lun 2273 are showing correct outputs except the
M10B wire (pin 3) this wire goes from start box to the circuit breaker
switch above engine (B16) on R version schematic then I traced it to V30
then to V19 at the rear of back cockpit. The wire is ok and not grounded
from start box to V19. And the panel switch above engine functions.
However the circuit appears grounded forward of the bulkhead at rear seat.
I have no idea even with the drawing where it goes next and V19 splits .
Any thoughts
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
I'm still looking for help on my start problem on R model.=C2- In brief,
all wires going to start box Lun 2273 are showing correct outputs except th
e M10B wire (pin 3) this wire goes from start box to the circuit breaker sw
itch above engine=C2- (B16) on R version schematic then I traced it to V3
0 then to V19 at the rear of back cockpit. The wire is ok and not grounded
from start box to V19. And the panel switch above engine functions.=C2- H
owever the circuit appears grounded forward of the bulkhead at rear seat.
=C2- I have no idea even with the drawing where it goes next and V19 spli
ts .=C2- Any thoughts
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: e: L29-List: |
Jake are you on-line?
> On Jul 23, 2016, at 16:56, schwartzcompany@att.net wrote:
>
>
>
> I'm still looking for help on my start problem on R model. In brief,
all wires going to start box Lun 2273 are showing correct outputs except
the M10B wire (pin 3) this wire goes from start box to the circuit
breaker switch above engine (B16) on R version schematic then I traced
it to V30 then to V19 at the rear of back cockpit. The wire is ok and
not grounded from start box to V19. And the panel switch above engine
functions. However the circuit appears grounded forward of the bulkhead
at rear seat. I have no idea even with the drawing where it goes next
and V19 splits . Any thoughts
>
>
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|