Today's Message Index:
----------------------
1. 07:06 AM - ALE-0030 rear elevator bell-crank (nick otterback)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | ALE-0030 rear elevator bell-crank |
To builders....
Any one has recieved the new rear bell crank ALE-0030 do not use it for final
install
The center arm is offset 10 degrees to the rear instead of 10 degrees to the
front as called for in the manual. The center horn should tilt forward and away
from the direction the the 3 hole end horn. The end horn is triangle shaped
if the triangle points back the horn should tilt forward.....I just want to make
the discription very clear here....i believe and so does the weld shop that
the few wich have been delivered are incorrect, we have a list and they do to
of the kits recieveing them. The weld shop is making news one stodya and will
have the correct ones out ASAP, so hold on to the ones you have and use it for
apnecil holder or something it is of no use...the wle dshop does not wan them
back for refit and we do not want to send refits to other customers....If you
ahve used this bell-crank to fit the elevators together that is fine the tir-horn
ends are correct and this can be used for fitting. If you have cut your
push pull tube based on this bell crank it will
simply be too long and can be shortend....
Nick Otterback
Arion Aircraft LLC
---------------------------------
Never miss a thing. Make Yahoo your homepage.
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|