Today's Message Index:
----------------------
1. 05:11 PM - Re: Matco brakes update with Torx Plus screw (n5pb@AOL.COM)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Matco brakes update with Torx Plus screw |
I'm Glad Matco is going in a better direction. I actually ordered extra ca
p head screws knowing the problems I had in the past. However, This looks
like a lot better nut and driver.
I'll be order in them first thing next week.
Thanks for the info Bill.
Bear
-----Original Message-----
From: Bill Strahan <bill@gdsx.com>
Sent: Thu, Jul 18, 2013 3:04 pm
Subject: Lightning-List: Matco brakes update with Torx Plus screw
I HATED the old cap head screws with the 1/8" hex drive. I stripped them
torquing them, I stripped them trying to get them out, and basically I just
felt
every time I used them I anticipated problems.
Speaking with George a couple weeks back he said they were getting Torx Plu
s
screws to replace them. I ordered them in anticipation of the next time I
needed to do any work on the wheels.
What a change. See them here:
http://www.matcomfg.com/TORXPLUSBUTTONHEADCAPSCREW-idv-3819-35.html
I also ordered two of the drivers, here:
http://www.matcomfg.com/DRIVET25IPTORXPLUSINSERT-idv-3820-35.html
I threw an extra set of screws and the drive in my travel toolkit.
These engage VERY securely, and I torqued each one to 80 inch/lbs no proble
m.
Yay! If you haven't upgraded yet, order them now so they're on hand and yo
u
don't have to mess with the hex drive screws ever again. That stuff was
starting to give me gray hair. ;)
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=404889#404889
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|